First
thing , is to build a jig, To
build a proper jig, I drew some center line both horizontal and
vertical. |
|
I then drew the perimeter
of the bulkhead. As mentioned on the plan I
repositioned the upper lower tube to compensate from the different
rolling radius of my planed tire size. |
|
I screwed in some block to
hold the tubes, were now ready to start
cutting and filling. |
|
Started cutting and fitting
the tubes that will make up the bulkhead.
|
|
Were now ready to tack and
weld the bulkhead, but before I'm going to secure the tubes with some
small block to hold the whole thing together, while tacking the
assembly. |
|